3D Printer Camera
Hopp til navigering
Hopp til søk
Setting up a Raspberry Pi as a camera server in the 3D printing room
Notes and tips from testing (24.11.2019)
- motionEyeOs seems to be a popular Linux distro to turn single-board computers into camera surveillance servers.
- Following the installation instructions and this video resulted in a successful setup using a Raspberry Pi 4.
- Initial impressions:
- The distro seems to be very light with fast bootup speed (also because of the power of Pi 4).
- There does not seem to be a `xyz.local` hostname to easily access the Pi, so finding the IP address is the only way. There are several ways, the laziest of which is to hook it up to a display while it is booting and read the bootup messages.
- The web UI is where all the config is done, though it can be a bit clunky.
@TODO
- Test the tool with several cameras and explore the different available settings.
