Metroplex 3D printer

Metroplex er en Monster Kossel 3D printer, designet og bygget av Jon C, som donerte den til Bitraf.

Den er fortsatt under bygging, ikke klar for bruk ennå.

Undersider: bygging, testing,

Om printeren

• type: Kossel (delta)
• build volume (diameter x height): 400 mm x 370 mm
• nozzle: 0.4 mm
• Hostnavn: metroplex-print.local

Extruder

Extruderen er laget av Dan Cook. Designet er ikke frigitt ennå.

Disassembly

To get access to the inside of the extruder, take out the 3 set screws that are around the base of the effector, pull the hotend assembly down, and you'll have clear access from the bottom for the gear slots.

Remove the bearings, and you can remove the hobbed wheel and the drive gear.

Pictures

Pictures and drawings of the extruder.

• 

  Extruder model

• 

  "x-ray" image of the worm gear, showing the coupling to the hobbed wheel

Pictures of the drive wheel and hobbed gear

• 

  overview

• 
• 
• 

Programvare

GZip-compressed Simplify3D FFF profile: Fil:Metroplex.fff.gz

Slicer parameters:

Fixed machine parameters:

Nozzle: 0.4mm

Filament: 1.75mm

Extrusion multiplier: 1.0

General Print speed: 70mm/s

Layer height: choose between 0.15 up to 0.3 mm

Movement speeds: X/Y/Z: 200mm/s

Retraction parameters

Retraction distance: 1.6mm

Retraction vertical lift: 0.6mm

Retraction speed: 35mm/s

Retraction coasting distance: 0.2mm

Print parameters

First layer height: 0.25 mm

First layer extrusion rate: 1.05 (105% width on Simplify3D)

Skirt: 3 perimeters at 3mm from part, 1 layer

Extruder temp: PLA: 215 C, PETG: 240 C

Heated bed: PLA: 60 C, PETG: 80 C

Cooling fan: PLA/PETG: start on layer 2 at 100%

Gcode: Marlin flavor

Print speeds

Outline print speed: 75% Solid infill speed: 100% Support speed: 100%

Historikk

For historikk til byggingen, se underside om bygging.