Forskjell mellom versjoner av «3D Printer Camera»
Hopp til navigering
Hopp til søk
(Ny side: === Setting up a Raspberry Pi as a camera server in the 3D printing room === <h5>Notes and tips from testing (24.11.2019)</h5> * [https://github.com/ccrisan/motioneyeos motionEyeOs] see…) |
|||
| Linje 7: | Linje 7: | ||
** The distro seems to be very light with fast bootup speed (also because of the power of Pi 4). | ** The distro seems to be very light with fast bootup speed (also because of the power of Pi 4). | ||
** There does not seem to be a `xyz.local` hostname to easily access the Pi, so finding the IP address is the only way. There are several ways, the laziest of which is to hook it up to a display while it is booting and read the bootup messages. | ** There does not seem to be a `xyz.local` hostname to easily access the Pi, so finding the IP address is the only way. There are several ways, the laziest of which is to hook it up to a display while it is booting and read the bootup messages. | ||
| − | ** The web UI | + | ** The web UI, where all the config is done, can be a little clunky. |
@TODO | @TODO | ||
* Test the tool with several cameras and explore the different available settings. | * Test the tool with several cameras and explore the different available settings. | ||
| − | |||
[[Category:camera]] [[Category:3D printing]] | [[Category:camera]] [[Category:3D printing]] | ||
Revisjonen fra 24. nov. 2019 kl. 22:57
Setting up a Raspberry Pi as a camera server in the 3D printing room
Notes and tips from testing (24.11.2019)
- motionEyeOs seems to be a popular Linux distro to turn single-board computers into camera surveillance servers.
- Following the installation instructions and this video resulted in a successful setup using a Raspberry Pi 4.
- Initial impressions:
- The distro seems to be very light with fast bootup speed (also because of the power of Pi 4).
- There does not seem to be a `xyz.local` hostname to easily access the Pi, so finding the IP address is the only way. There are several ways, the laziest of which is to hook it up to a display while it is booting and read the bootup messages.
- The web UI, where all the config is done, can be a little clunky.
@TODO
- Test the tool with several cameras and explore the different available settings.
