Forskjell mellom versjoner av «Making your own reels from cutoffs»
Hopp til navigering
Hopp til søk
(Ny side: This is the process for making your own reels using [https://www.allsmt.com/SMT-Splice-Tool the SMT Splice Tool] purchased from AllSMT. You'll use similar gear in the same way. Start by…) |
|||
| Linje 3: | Linje 3: | ||
Start by getting the special plier tool and the clips from the shelf above the [Pick_and_place] machine. Open the tool and put a metal clip so the holes align up as in the picture. If you feel the clip, it has small and sharp protrusions sticking out on once side. Make sure these align to the top and the smooth side down. These will press into the holes on the reel pieces we are joining. | Start by getting the special plier tool and the clips from the shelf above the [Pick_and_place] machine. Open the tool and put a metal clip so the holes align up as in the picture. If you feel the clip, it has small and sharp protrusions sticking out on once side. Make sure these align to the top and the smooth side down. These will press into the holes on the reel pieces we are joining. | ||
| − | [[Fil:SMT Tool, adding clip.jpg| | + | [[Fil:SMT Tool, adding clip.jpg|400px|miniatyr|venstre]] |
Revisjonen fra 2. nov. 2022 kl. 13:05
This is the process for making your own reels using the SMT Splice Tool purchased from AllSMT. You'll use similar gear in the same way.
Start by getting the special plier tool and the clips from the shelf above the [Pick_and_place] machine. Open the tool and put a metal clip so the holes align up as in the picture. If you feel the clip, it has small and sharp protrusions sticking out on once side. Make sure these align to the top and the smooth side down. These will press into the holes on the reel pieces we are joining.
