Forskjell mellom versjoner av «FormLabs - matrialkvalitet»
Hopp til navigering
Hopp til søk
| Linje 18: | Linje 18: | ||
|- | |- | ||
| '''Tensil Properties''' | | '''Tensil Properties''' | ||
| − | | | + | | style="height:100px; width:100px; text-align:center;" |
| Ultimate Tensile Strength|| 24 MPa|| 36 MPa|| 52 MPa | | Ultimate Tensile Strength|| 24 MPa|| 36 MPa|| 52 MPa | ||
| − | |- | + | | style="height:100px; width:100px; text-align:center;" |
| Tensile Modulus|| 0.8 GPa|| 1.7 GPa|| 2.3 GPa | | Tensile Modulus|| 0.8 GPa|| 1.7 GPa|| 2.3 GPa | ||
| − | |- | + | | style="height:100px; width:100px; text-align:center;" |
| Elongation at Break|| 14%|| 5%|| 4% | | Elongation at Break|| 14%|| 5%|| 4% | ||
|- | |- | ||
Revisjonen fra 20. des. 2022 kl. 05:58
3D printing Resin - Hvordan? - Form 3 - PreForm - Dashboard - Form Wash & Form Cure - Material utvalg - Matrial kvalitet - Farge blanding
Draft Resin
| DRAFT MATERIAL PROPERTIES DATA | GREY MATERIAL PROPERTIES DATA | ||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Green | Post-Cured at Room Temperature | Post-Cured at 60 °C | Green | Post-Cured at Room Temperature | Post-Cured at 60 °C | ||||||||||
| Tensil Properties | style="height:100px; width:100px; text-align:center;" | Ultimate Tensile Strength | 24 MPa | 36 MPa | 52 MPa | style="height:100px; width:100px; text-align:center;" | Tensile Modulus | 0.8 GPa | 1.7 GPa | 2.3 GPa | style="height:100px; width:100px; text-align:center;" | Elongation at Break | 14% | 5% | 4% |
| Flexural Properties | |||||||||||||||
| Flexural Modulus | Celletekst | Celletekst | Celletekst | ||||||||||||
| Impact Properties | |||||||||||||||
| Elongation at Break | Celletekst | Celletekst | Celletekst | ||||||||||||
| Temperature Properties | |||||||||||||||
| Elongation at Break | Celletekst | Celletekst | Celletekst | ||||||||||||
