Forskjell mellom versjoner av «FormLabs - matrialkvalitet»
Hopp til navigering
Hopp til søk
| Linje 19: | Linje 19: | ||
| '''Tensil Properties''' | | '''Tensil Properties''' | ||
|- | |- | ||
| − | | Ultimate Tensile Strength|| | + | | Ultimate Tensile Strength|| 24 MPa|| 36 MPa|| 52 MPa |
|- | |- | ||
| − | | Tensile Modulus|| | + | | Tensile Modulus|| 0.8 GPa|| 1.7 GPa|| 2.3 GPa |
|- | |- | ||
| − | | Elongation at Break|| | + | | Elongation at Break|| 14%|| 5%|| 4% |
|- | |- | ||
| '''Flexural Properties''' | | '''Flexural Properties''' | ||
Revisjonen fra 20. des. 2022 kl. 05:56
3D printing Resin - Hvordan? - Form 3 - PreForm - Dashboard - Form Wash & Form Cure - Material utvalg - Matrial kvalitet - Farge blanding
Draft Resin
| DRAFT MATERIAL PROPERTIES DATA | GREY MATERIAL PROPERTIES DATA | |||||
|---|---|---|---|---|---|---|
| Green | Post-Cured at Room Temperature | Post-Cured at 60 °C | Green | Post-Cured at Room Temperature | Post-Cured at 60 °C | |
| Tensil Properties | ||||||
| Ultimate Tensile Strength | 24 MPa | 36 MPa | 52 MPa | |||
| Tensile Modulus | 0.8 GPa | 1.7 GPa | 2.3 GPa | |||
| Elongation at Break | 14% | 5% | 4% | |||
| Flexural Properties | ||||||
| Flexural Modulus | Celletekst | Celletekst | Celletekst | |||
| Impact Properties | ||||||
| Elongation at Break | Celletekst | Celletekst | Celletekst | |||
| Temperature Properties | ||||||
| Elongation at Break | Celletekst | Celletekst | Celletekst | |||
