Forskjell mellom versjoner av «FormLabs - matrialkvalitet»
Hopp til navigering
Hopp til søk
| Linje 20: | Linje 20: | ||
|- style="height:100px; width:100px; text-align:center;" | |- style="height:100px; width:100px; text-align:center;" | ||
| Ultimate Tensile Strength|| 24 MPa|| 36 MPa|| 52 MPa|| 38 MPa|| 65 MPa|| | | Ultimate Tensile Strength|| 24 MPa|| 36 MPa|| 52 MPa|| 38 MPa|| 65 MPa|| | ||
| − | |- | + | |- style="height:100px; width:100px; text-align:center;" |
| Tensile Modulus|| 0.8 GPa|| 1.7 GPa|| 2.3 GPa | | Tensile Modulus|| 0.8 GPa|| 1.7 GPa|| 2.3 GPa | ||
|- | |- | ||
Revisjonen fra 20. des. 2022 kl. 05:03
3D printing Resin - Hvordan? - Form 3 - PreForm - Dashboard - Form Wash & Form Cure - Material utvalg - Matrial kvalitet - Farge blanding
Draft Resin
| DRAFT MATERIAL PROPERTIES DATA | GREY MATERIAL PROPERTIES DATA | |||||
|---|---|---|---|---|---|---|
| Green | Post-Cured at Room Temperature | Post-Cured at 60 °C | Green | Post-Cured at Room Temperature | Post-Cured at 60 °C | |
| Tensil Properties | ||||||
| Ultimate Tensile Strength | 24 MPa | 36 MPa | 52 MPa | 38 MPa | 65 MPa | |
| Tensile Modulus | 0.8 GPa | 1.7 GPa | 2.3 GPa | |||
| Elongation at Break | 14% | 5% | 4% | |||
| Flexural Properties | ||||||
| Flexural Modulus | Celletekst | Celletekst | Celletekst | |||
| Impact Properties | ||||||
| Elongation at Break | Celletekst | Celletekst | Celletekst | |||
| Temperature Properties | ||||||
| Elongation at Break | Celletekst | Celletekst | Celletekst | |||
