FormLabs - matrialkvalitet: Forskjell mellom sideversjoner
Hopp til navigering
Hopp til søk
Ingen redigeringsforklaring |
Ingen redigeringsforklaring |
||
| Linje 20: | Linje 20: | ||
|- style="height:100px; width:100px; text-align:center;" | |- style="height:100px; width:100px; text-align:center;" | ||
| Ultimate Tensile Strength|| 24 MPa|| 36 MPa|| 52 MPa | | Ultimate Tensile Strength|| 24 MPa|| 36 MPa|| 52 MPa | ||
| style="height:100px; width:100px; text-align:center;" | | - style="height:100px; width:100px; text-align:center;" | ||
| Tensile Modulus|| 0.8 GPa|| 1.7 GPa|| 2.3 GPa | | Tensile Modulus|| 0.8 GPa|| 1.7 GPa|| 2.3 GPa | ||
| style="height:100px; width:100px; text-align:center;" | | - style="height:100px; width:100px; text-align:center;" | ||
| Elongation at Break|| 14%|| 5%|| 4% | | Elongation at Break|| 14%|| 5%|| 4% | ||
|- | |- | ||
Sideversjonen fra 20. des. 2022 kl. 03:59
3D printing Resin - Hvordan? - Form 3 - PreForm - Dashboard - Form Wash & Form Cure - Material utvalg - Matrial kvalitet - Farge blanding
Draft Resin
| DRAFT MATERIAL PROPERTIES DATA | GREY MATERIAL PROPERTIES DATA | ||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Green | Post-Cured at Room Temperature | Post-Cured at 60 °C | Green | Post-Cured at Room Temperature | Post-Cured at 60 °C | ||||||||
| Tensil Properties | |||||||||||||
| Ultimate Tensile Strength | 24 MPa | 36 MPa | 52 MPa | - style="height:100px; width:100px; text-align:center;" | Tensile Modulus | 0.8 GPa | 1.7 GPa | 2.3 GPa | - style="height:100px; width:100px; text-align:center;" | Elongation at Break | 14% | 5% | 4% |
| Flexural Properties | |||||||||||||
| Flexural Modulus | Celletekst | Celletekst | Celletekst | ||||||||||
| Impact Properties | |||||||||||||
| Elongation at Break | Celletekst | Celletekst | Celletekst | ||||||||||
| Temperature Properties | |||||||||||||
| Elongation at Break | Celletekst | Celletekst | Celletekst | ||||||||||