Vakuum bord til Shopbot

Fra Bitraf
Revisjon per 27. aug. 2026 kl. 14:13 av Dragevald (diskusjon | bidrag)
(diff) ← Eldre revisjon | Nåværende revisjon (diff) | Nyere revisjon → (diff)
Hopp til navigering Hopp til søk

Parts available

  1. CNC-plus VT-4070 board (hanging on the wall) - https://cnc-plus.de/en/Workholding/vacuum-clamping-tables/VT-4070-Vacuum-Table--Vacuum-Clamping-Plate-400x700mm-.html
  2. CNC-plus VT-4070 tubes (in a transparent box under Shopbot)
  3. Becker KVT 3.100 Vacuum Pump(under Shopbot) - https://www.becker-international.com/de/en/products/vacuum-pumps/rotary-vane-vacuum-pumps-oil-free/kvt3.100.htm

Process

  1. Mount the VT-4070 board. Use the mounting holes it has.
  2. Connect the tubes to the vacuum pump
  3. Connect the 3-phase power cable of the vacuum pump (long cable)
  4. Place your material (there are dowel pins that match the board in the tubes box). Make sure area that is not used is covered.
  5. Start the vacuum pump. Test good suction is in place. It is your responsibility to make sure enough suction is available.
  6. Start milling (or cutting with the drag knife you can find in the tubes box).
Hentet fra «https://wiki.bitraf.no/w/index.php?title=Vakuum_bord_til_Shopbot&oldid=11058»